CompuSTAR 2W803R-SS Manuale di Installazione

Please visit techfeed.compustar.com for additional installation resourcesFirstech, LLC.21903 68th Ave S.Kent, WA 98032Phone. 888-820-3690Fax. 206-95

Knock Panel SensitivityTo change knock sensitivity, disarm the system and adjust the switch on the rear of the RPS. The larger the circle, the more se

Testing The DAS SensorSTEP 1: Turn the ignition off and Arm/Lock the system. STEP 2: Wait 30 seconds then test the impact sensitivity.FT-EZGO SetupThe

Jumper SettingsCaution: Jumper settings affect the polarity and use of certain outputs. If these jumpers are used incorrectly, damage to the vehicle

Jumper 2 (2nd Ignition / 2nd Starter / 2nd Parking light)Jumper 2 sets the behavior of the large blue wire on Connector 1. This wire is powered by an

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 15CM7200 Master GuideStarter Systemtechfeed

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Connector 1 (CN1), 8-PinPin 1 Red - Constant 12V positive (+) power input. This wire must be connected. The proper wire will test (+) 12V at all times

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 19CM7200 Master GuideStarter Systemtechfeed

Introduction 4Kit Contents 4Installation Basics 5Remote Programming Routine 6Valet Mode 6Placement

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 21CM7200 Master GuideStarter Systemtechfeed

Pin 18 Yellow/Black - Engine sensing input (A/C): This wire is connected to the vehicle’s Tach or Alternator wire and is required when using the tach

Pin 2 Black/White – thermister: temp resistance input. Connector 9 (CN9), 4-Pin to 4-Pin or 6-Pin (Pre-wired Antenna Cable)Connect your antenna cable

Pin 3 Orange/Black - 2nd Unlock 250mA negative (-) output: This is an optional output that will provide a (-) pulse for driver’s priority door lock. I

Option Programming TablesCopyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 25CM7200 Master Gu

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Special Option Group 1Feature Setting Value (Seconds)1 Diesel Timer - DISL 3 ~ 992 AUX1 output time 1 ~ 1003 AUX2 output time 1 ~ 1004 AUX3 output tim

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 29CM7200 Master GuideStarter Systemtechfeed

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3CM7200 Master GuideStarter Systemtechfeed.

1-06 Reservation Lock: Optional manual transmission reservation mode procedures.FO1 - Locks before set: (default) this option will lock the doors bef

1-09 Ignition Controlled Locks: When FO 2-4 are selected, the user can activate the “drive lock” or ignition controlled door locking feature using a F

1-13 Double pulse disarm: This feature enables the FAD output. It will pulse 2 times with a single disarm command.FO1 - Off (default): Standard singl

2-01 Tach Sensing Method: This feature will determine the point at which the CM7 releases the starter based on the sampled tach method.FO1 - Optimal T

2-04 Trigger Start: This feature changes the number of pulsed inputs (min of 60mS per pulse) on the trigger start input wire. (Pink wire CN5). Note: I

FO3 - Reserve runtime: (runtime based on feature 2-07 option setting) Note: 2 way LCD remote required. This option will allow the user to set a predet

2-10 Engine Sensing: This feature provides 4 options for engine sensing methods. Every CM7 is shipped in manual transmission mode. Tach sensing is our

2-14 PIC 1 (-): Programmable Input Channel provides 4 options for negative input to the CM7.FO1 - (-) negative E-brake (aka: parking brake) input: Thi

3-03 Dome Light Delay: This option is used when connecting the door trigger input to the vehicles dome light circuit. It delays the door trigger input

FO4 - On double lock and Start: this option is design to simulate a factory keyless entry system by providing a horn output pulse (based on the option

All Firstech FT-7200S CONT controllers include the following:• CM7200 main control module• Wiring diagram sheet• High Current ignition harness with

3-12 VAC: (Thermister required) this determines the temperature at which the CM7 will provide an output on any POC programmed with setting 22(VAC: Ven

3-15 Soft Disarm: this feature will enable Factory Alarm Arm (FAA) and Factory Alarm Disarm (FAD) outputs to trigger when silencing the Compustar sire

4-02 Aux 2 Output: This feature determines the duration of the auxiliary 2 output. (Option 4 allows the output duration to be set for a specific le

FO3 - With Disarm: this option will trigger AUX 2 (output time based on feature 4-02) any time the CM7 is unlocked/disarmed. Note: the system has to b

4-10 PIC 4 (+): (Programmable input Channel 4 CN5 pin 14 Pink) this feature will determine the input function of PIC4.FO1 - Trigger start input: This

FO3 - 48hrs (2 days): This option will allow the antenna to power down 48hrs after being armed. Note: once the antenna has powered down, 1 Way operati

This special option group allows you to determine the output type of the POC wire. For example, if you want to set POC #5 (default setting status out)

SV 10 - AUX1: provides a 250mA (-) negative output when AUX is triggered by Firstech 4 button remote, 2way LCD remote, or Drone, on any POC programmed

How to Program OptionsThere are two ways to set options on the CM7 control modules. You can use the FT-OP500-KIT or most Firstech remotes. The remotes

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 49CM7200 Master GuideStarter Systemtechfeed

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 5CM7200 Master GuideStarter Systemtechfeed.

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Remote Start Error CodesIf the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those two fla

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 52CM7200 Master GuideStarter Systemtechfeed

I need a ground when armed wire, does the control module have one?A: You can use pin 1-blue/white wire on the Grey Connector 5. You must cut this wire

What is this cartridge slot on the CM7000, CM7200, and CM6300?A: This is the slot for the Blade cartridge system. This slot is for the Idatalink Blade

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 7CM7200 Master GuideStarter Systemtechfeed.

Copyright 2014 Firstech, LLC. Page 2Copyright 2014 Firstech, LLC. Page 2CM7200 Master GuideStarter Systemtechfeed.compustar.comCopyright 2014 Firstech

Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 3Copyright 2014 Firstech, LLC. Page 9CM7200 Master GuideStarter Systemtechfeed.